Posts Tagged: narrow gauge railroad



EB&L Railroad, Narrow Gauge Line

This map shows the general layout of the East Branch & Lincoln Railroad’s “Narrow Gauge”. The EB&L Railroad was a standard gauge railroad, but in 1901 J.E. Henry and Sons attempted to use a narrow gauge line at Camp 8 to harvest timber from the slopes of Whaleback Mountain. This roughly 1.25 mile +/- long line,  consisting of a series of switchbacks, traveled into the Osseo Brook drainage. It lasted only for a few years and was discontinued after a brakeman was killed when a loaded log car ran out control down the track.
1900s EB&L Narrow Gauge Railroad – Courtesy of the Upper Pemigewasset Historical Society
 

EB&L Railroad, Narrow Gauge Line – In operation from 1893-1948, the East Branch & Lincoln (EB&L) was a standard gauge railroad. But in 1901 J.E. Henry and Sons attempted to use a narrow gauge railroad to harvest timber from the Whaleback Mountain (Mt Osseo) area. With the exception of a May 1902 article by Albert W. Cooper and T.S. Woolsey, Jr. in Forestry & Irrigation little is known about this short-lived railroad. There are only a few photos (above) of the railroad, and over the years the actual location has been in question.

The difference between standard gauge and narrow gauge railroads is the spacing between the rails. The spacing on standard gauge railroads is 4 feet 8 1⁄2 inches, while the spacing on narrow gauge railroads is 3 feet 6 inches (this can range some). Narrow gauge railroads usually cost less to build and operate, but the major drawback is they can't handle heavy loads. The logging railroads in the White Mountains preferred the heavy standard gauge lines for hauling timber.

Continue reading right arrow